";s:4:"text";s:3396:" Light it up, and tidy up the wiring to your taste! There are two cabinets adjacent to each other with the lights running down opposite sides, so the figures get a fairly decent amount of lighting. When I first received this set, I was a bit confused on how everything goes. I was lurking around another statue collecting forum and someone had suggested the $39.99 Dioder kit from Ikea. I noticed in the FAQ it suggests the IKEA Dioder LEDs but they aren't available to order online, and there is no IKEA near me. No supports were needed on my Aurora A3 with PLA with an 0.25 mm layer height. This kit has been especially designed to be installed directly into the IKEA Detolf display cabinet and is suitable for all collectible displays. I have the same setup, except my lights run down one side of the cabinet. No box. You may want to drill holes in the bottom of the Detolf case to run the Dioder wires out of. Unlike other LED kits on the market, this hides all the wiring and LEDs from view giving you the Clip everything together! Hi collectors, this question has been asked millions of times, however I couldn't find one proper LED to choose from. Strip the ends of the wire, and attach a 2.1mm female power adaptor. I picked up ikea lighting set for 20 bucks. So we searched for an alternative, that is small, easy to attach and casts a nice warm light. Print 6 of them in the orientation shown in the build photo. Risers also help with these. I think the LED strip might emit light more evenly then the LED dioder kit over each shelf but I didnt wanna get colored lightning for picture taking purposes. With the detolf and the dioder lighting setup, my general rule is top most part needs to be near the front to avoid shadows showing up on the front most figures. And that’s my story. I've been looking to light my Detolfs for a while but wanted to avoid the halogen Non lighting because of heat. For those of you concerned about lighting in this way, don't worry!